1.75mm EasyCork™ - Light

1.75mm EasyCork™ - Light

Tootekood: 8718924475973
Ühik: tk 500g
Tarneaeg: 3 päeva
Hind: 35,32 € 24,72 €
Kogus: tk 500g Lisa korvi

EasyCork™ on väga kerge ca 30% ulatuses korgiga täidetud PLA tüüpi lõng. EasyCork™ lõngal on korgi sarnased omadused, võimaldades printida ilusaid korgi välimuse ja omadustega detaile.

EasyCork™ on saadaval heleda ja tumeda korgi toonina. EasyCork™ on kergelt prinditav EasyFil™ PLA baasil lõng.



EasyCork is a lightweight cork-filled PLA-based filament which is gravimetrically filled with approximately 30% cork fibres. The gravimetric filling with relatively lightweight cork fibres means that EasyCork has extremely high volumetric cork filling properties, allowing you to 3D print beautiful objects with great cork-like aesthetics and cork-like properties such as being lightweight and impact resistant.
EasyCork is a very easy to print material as it is based on our EasyFil PLA compound and the 30% gravimetrical filling with cork fibres make the filament absolutely warp-free.


Unique features

  • High cork filling
  • Real cork feel, look and smell
  • Warp-free printing
  • Great thermal stability and filament flowing behaviour
  • Perfect first- and inter-layer adhesion
  • Can be printed at high printing speeds
  • Very easy to print
  • Lightweight and impact resistant


General printing guidelines *

Nozzle size: ≥ 0.4mm

Layer height: ≥ 0.25mm

Flow rate: ± 100%

Print temp: ± 210 - 260° C

Print speed: High

Retraction: Yes ± 5mm

Heat bed: ± 0 - 60° C

Fan speed: 50-100%

Experience level: Beginner

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.


Filament length

ρ: 1.027 g/cc

50 gr coil

0.5 Kg spool

Ø 1.75mm

± 20.2m

± 202m

Ø 2.85mm

± 7.6m

± 76m


Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.


Product export information

HS Code: 39169090

Description: Monofilament

Country of origin: the Netherlands


Compliance *

This filament is compliant to below listed directives and regulations.

  • RoHS directive 2011/65/EC
  • REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.